• Thermal wave imaging techniques for inspection of plywood materials 

  Mulaveesala, R.; P Nagarjuna, V.; Ravi, D.; Amarnath, M. (2022-12-22)

  Infrared non-destructive testing and evaluation (IRNDT&E) is an emerging approach for materials characterization due to its capability to test wide variety of solid materials such as metals, composites and semiconductors ...
• Effect of Co-Zr doping in the M-Type barium hexaferrite BaCoxZrxFe(12- 2x)O19: A Möss 

  Chawla, S.K.; Mudsainiyan, R.K.; Meena, S.S.; Yusuf, S.M.; Singh, N. (2022-12-22)

  M- type hexagonal ferrites BaCoxZrxFe (12-2x)O19 (x = 0, 0.4 & 1.0) have been prepared by a sol-gel route. Mössbauer Spectroscopy is employed to probe the changes in the structural and magnetic properties at the microscopic ...
• Improving the tribological properties of mg based AZ31 alloy using friction stir processing 

  Arora, H.S.; Singh, H.; Dhindaw, B.K.; Grewal, H.S. (2022-11-11)

  Materials with improved tribological properties have become the pre-requisite of advanced engineering design. Surface metal matrix composites (SMMCs) exhibit a unified combination of good tribological properties and high ...
• Non-destructive evaluation of concrete structures by nonstationary thermal wave imaging 

  Mulaveesala, R.; Panda, S.S.B.; Mude, R.N.; Amarnath, M. (2022-09-09)

  Reinforced concrete structures (RCS) have potential application in civil engineering and with the advent of nuclear engineering RCS to be capable enough to withstanding a variety of adverse environmental conditions. However, ...
• Methods of solution of singular integral equations 

  Chakrabarti, A.; Martha, S.C. (2022-09-09)

  Purpose: This paper investigates a different method to evaluate different real improper integrals and also to obtain the solutions of various types of Cauchy-type singular integral equations of the first kind. Methods: ...
• Effect of process parameters on splat formation during impingement of liquid metal droplets over a cold substrate 

  Kumar, A.; Sahoo, S.; Ghosh, S.; Dhindaw, B. K. (2021-11-13)

  Molten metal droplet impingement is an integral part of droplet based manufacturing processes like spray casting and sprays coating. In these processes, in a single operation, a liquid metal stream is atomized into fine ...
• Numerical simulation of erosion using computational fluid dynamics 

  Grewal, H. S.; Singh, H.; Agrawal, A. (2021-11-13)

  Erosion in industrial appliances causes huge loss of valuable resources especially when solid particles are present in the working medium. A number of erosion models that are available in the literature claimed to predict ...
• Matched excitation for thermal nondestructive testing of carbon fiber reinforced plastic materials 

  Mulaveesala, R.; Subbarao, G. V.; Amarnath, M. (2021-11-13)

  Active thermographic studies proved their capabilities for detection of deeper subsurface details with reduced non uniform emissivity problems for defect detection. In this contribution analysis of subsurface anomalies ...
• Did the metamorphosis from export processing zones to special economic zones improve the efficiency of trade enclaves in india? 

  Tantri, M. L. (2021-11-13)

  In this paper, the efficiency of seven conventional Special Economic Zones in India is analyzed, by adopting a stochastic production frontier technique, for the period between 1986–1987 and 2007–2008.Results indicate ...
• Effectiveness of the special economic zone policy over the export processing zone structure in india: trade performance at the aggregate level 

  Tantri, M. L. (2021-11-13)

  Empirical evidence on the effectiveness of recent India’s Special Economic Zone (SEZ) policy over Export Processing Zone structure is analysed in this article by aggregating data of seven conventional SEZs from 1986–1987 ...
• Debating contribution vis-à-vis equity principle in tax sharing: a review of recommendations of the finance commission of india 

  Datta, P. (2021-11-13)

  This article discusses the objectives of the Finance Commission of India since inception, within the ambit of critical issues in public finance. Amidst increasing political tensions between the central and state governments ...
• Dual growth modes in ion bombarded Si surfaces 

  Dhillon, P. K.; Sarkar, S. (2021-10-27)

  Morphological studies were done on Si (001) surfaces after rastering them with a 1 keV O2 + ion beam at an angle. The resulting mounded morphology was studied using atomic force microscopy (AFM) measurements. ...
• Multiunit planning assessment of wind power: Sensitivity to wind regimes 

  Roy, S. (2021-09-18)

  —If proposed wind park configurations are planned through a globally coordinated approach across a utility service area, then electricity can be fed into the grid with substantial cost advantages. This paper shows that ...
• Analysis of the wave properties of a new two-lane continuum model with the coupling effect 

  Gupta, A. K.; Sharma, S. (2021-09-18)

  A multilane extension of the single-lane anisotropic continuum model (GK model) developed by Gupta and Katiyar for traffic flow is discussed with the consideration of the coupling effect between the vehicles of different ...
• Low-energy rotational inelastic collisions of H + + CO system 

  Kumar, T. J. D.; Kumar, S. (2021-09-18)

  The quantum mechanical state-to-state rotational excitation cross sections have been computed using the ab initio ground electronic state potential energy surface of the system [M. Mladenovic and S. Schmatz, J. Chem. Phys. ...
• Impact of short duration wind variations on output of a pitch angle controlled turbine 

  Roy, S. (2021-09-18)

  The distorted output of a pitch angle controlled (PAC) horizontal axis turbine, as influenced by short duration wind variations like turbulence and gusts, is analyzed under the assumption of two-parameter Weibull statistics. ...
• Modelling the underlying principles of human aesthetic preference in evolutionary art 

  Eka´rt, A.; Joo, A.; Sharma, D.; Chalakov, S. (2021-09-18)

  Our understanding of creativity is limited, yet there is substantial research trying to mimic human creativity in artificial systems and in particular to produce systems that automatically evolve art appreciated by ...
• Influence of -SO 3H functionalization (N-SO 3H or N-R-SO 3H, where R = alkyl/benzyl) on the activity of brönsted acidic ionic liquids in the hydration reaction 

  Kore, R.; Srivastava, R. (2021-09-18)

  Sulfonic acid group functionalized imidazole based Brönsted acidic ionic liquids (BAILs) were synthesized and their activities were investigated in the hydration reaction of alkynes. The Hammett acidity order determined ...
• The importance of being relevant 

  Jaswal, S. (2021-09-18)

  This review aims at an understanding of the binding process by synthesizing the extant perspectives regarding binding. It begins with a consideration of the biological explanations of binding, viz., conjunctive coding, ...
• Benzimidazole-based fluorescent sensors for Cr 3+ and their resultant complexes for sensing HSO 4- and F - 

  Saluja, P.; Kaur, N.; Singh, N.; Jang, D. O. (2021-09-18)

  A benzimidazole-based receptor that selectively recognized Cr3þ without interference from other metal ions was synthesized in this study. The resultant Cr-complex recognized HSO4 and F via two approaches. HSO4 ions ...

View more